i-team i-mop Lite, Руководство пользователя

Страница: 29 / 43

29
6.3. Cleaning and storage
6.3.1 Flushing the system
Be sure to flush the tanks out completely to
discard any remaining solution in the lines and
valves:
1.
Refill the solution tank with 2 to 4 cups /
0.5 to 1 liter of clean water.
2. Press the Brush and Cleaning solution and
Vacuum buttons on the control panel.
3. Use the trigger to start the imop Lite and
allow it to flush the system.
Figure 21
6.3.2 Cleaning the tanks
1. Dispose of water or cleaning solution from both tanks in an appropriate drain.
2. To clean the recovery tank thoroughly:
•
Partially fill the tank with fresh water and hold it horizontally with the holes facing up.
•
Tilt the tank repeatedly, thoroughly rinsing all the dirt and debris out from the tank.
3. To clean the solution tank, follow the same procedure.
6.3.3 Cleaning the filter
TIP: Dry the tanks
Slightly open both tank caps before storage to allow the tanks to dry.