EN-6
Note
5 seconds after the device disconnected with Ethernet cable, and the adapter
will automatically switch to the power-saving Mode.
In power-saving mode, the Homeplug cannot be accessed via the electrical
wiring and all LEDs will be off, but its integrated electrical socket can supply
the power normally. As soon as the Ethernet cable connected to the Homeplug
is switched on again, your Homeplug will leave the power-saving mode and
the three LEDs will flash simultaneously.
There are four physical interfaces on this Powerline Adapter.
Ethernet Port:
It is a 10/100Mbps Ethernet port on the adapter for connecting it to the PC
or the broadband device with the network cable.
Power Plug:
A Power Plug connected to any 100V ~ 240V AC (50~60Hz) power socket
Pair Button:
Pair buttons are used to secure a powerline network. To secure your network,
please follow the steps below. Firstly, plug in a new adapter, and press its pair button for
1 second; then plug in another adapter and press its pair button for 1 second as well. The
two buttons should be pressed within 2 minutes of each other. After that, wait about 60
seconds so that the two adapters can finish connecting.
Integrated Electrical Socket:
The integrated electrical socket allows additional devices
or multiple sockets to be connected to the adapter just like to a normal wall socket. No
electrical socket is lost.
Note
The provided power plug may differ from the picture due to different regional
power specifications. Here we take the EU version as an example.
If you press the pair button for more than 10 seconds, the powerline adapter
will leave the network which it has joined and its new network name assumes
a random value. The Power LED turns off temporarily when it disconnects from
Downloaded from www.vandenborre.be
