13
Major operating controls and their functions
(continued)
Rear view
①
Security wire hole
Mount the lock device for the anti-theft security wire.
②
Alarm/Control connector ALARM/CONTROL
It is used when connecting with an external device, such
as sensor or anti-theft door switch that output alarm
signal and when connecting external alarm device, such
as buzzer and lamp.
Two included terminal plugs (12 pin) can be attached.
③
Cable clamp fixing hole (for fixing the terminal
block cables)
This is a fitting hole for the cable clamp (included) to tie and
fix the terminal block cables. Refer to
☞
④
Main monitor output connector (HDMI) [A/V MAIN]
This connector is used to connect to an HDMI-ready
monitor (the main monitor). It displays live images,
recorded images, or the setup menu of the recorder.
⑤
Sub monitor output connecter (HDMI) [VIDEO SUB]
This connector is used to connect to an HDMI-ready
monitor (sub monitor). Only the live images will be
displayed.
⑥
Network port (PC port) [PC]
Connect the recorder with a PC via a network
compatible with 10BASE-T, 100BASE-TX or
1000BASE-T. Use this port when the cameras and the
PC are connected to different network.
⑦
Network port (Camera/PC port) [CAMERA/PC]
Connect the recorder with a PC and cameras via a
network compatible with 10BASE-T, 100BASE-TX or
1000BASE-T. Only the right indicator (orange) lights
during linking up at 1000M, only the left indicator (green)
lights during linking up at 100M, and both indicators light
during linking up at 10M. The indicator blinks when data
is being sent or received.
Camera/PC
PC
(10/100/1000 BASE-T)
⑧
Cable clamps fixing holes (for fixing the copy port
cables)
Fit the cable clamp (included) to fix the copy port
connection cable. Refer to
☞
page 15 for fixing.
⑨
Copy port (USB3.0) COPY (×2)
Connect an external storage device (external Hard disk
drive, USB memory) to this port and copy images and
audio recorded on the hard disk drive. An external
storage device can also be connected to the copy port
on the front. Use one of them.
⑩
Power cord clamp mount
Fit the power cord clamp (included) to fix the power
cord. Refer to
☞
page 14 for fixing.
⑪
SIGNAL GND terminal [SIGNAL GND]
Connect this terminal with the SIGNAL GND terminals of
the devices in the system for signal ground. When
operating the recorder and the devices in the system
without signal ground, noise may be produced.
⑫
Power cord inlet [AC IN]
Connect the included power cord to this inlet.
⑬
Cooling fan outlet
②
①
④
⑤
③
⑩ ⑪
⑥ ⑦
⑧ ⑨
⑫
⑬
