USER INSTRUCTION
Ref: SRF-E27
Product Content:
1 Mini Remote Control Lamp Socket ref: SRF- E27
Remote Control Light Socket Switch for E27 Bulb
Technical Data:
Mini Remote Control Lamp Socket ref: SRF- E27 -
E27 Cap
Power Supply 100-240V ~50/60 Hz
Supported Power: 100W max.
Standby Power Consumption: 1W
Dimensions: H 70 mm x Ø 40 mm
Compatible* with Lamps Types:
* not compatible with a voltage converter.
Common Coding Button and On / Off
Memorization of 4 different commands (remote control, switch...)
Remote Controls:
Features:
Range of 100m in free field (no obstacles)
Range of 50m (with barriers)
Transmission frequency: 433.92 MHz
1) Turn off the power supply for your light fixture or
electric table.
2) Unscrew the lamp (Cold).
Installation with multiple RF sockets
3) Place the remote control socket by screwing it.
Remote controllable, you must keep at least 1 meter
distance between each socket in order not to disturb the
radio frequency signals.
4) Screw on lamp on the mini remote control socket.
5) Reconnect the power supply of your luminaire or elec-
trical switchboard and press the socket button to turn on
the lamp. Press the button again to turn off.
This socket can be installed in a luminaire by inserting it between
its lamp and its base socket E27.
For outdoor use, it is necessary that your luminaire has a clue
protection against moisture of a minimum IP44.
It is not recommended to use this RF socket in a wrapped lumi-
naire metal protection at the location where it will be placed, the
reception of radio waves will be greatly reduced.
6) You will proceed to the coding (association)
Here is an example of encoding the socket with a remote
control ref: TEL-010
Coding Button and On / Off (Test)
7) On the socket, press and hold the encoding button, the LED will
flash, on the Remote press once on the top of the left plate (START
button). Then release the coding button. The socket is coded with
the remote. For other locations, the process will remain the same.
8) Perform a test with the switch:
Start: top support Stop: down support
For your information, this socket can memorize 3 other
commands (in total 4)
START BUTTON
STOP BUTTON
9) To erase any codes stored on the socket, press and hold the en-
coding button for 10 seconds, after that time 6 flashes of the lamp will
occur, then release the socket button.
To redo the coding, start again from step 6.
