Hyundai N800 Series, Руководство по установке

Страница: 93 / 102

7. TECHNICAL DATA
87
NOTE!
The rated currents in given ambient temperatures (in Table 36 The technical data of the N800A AC drive) are
achieved only when the switching frequency
≤ the factory default.
If your process includes a cyclical load, for example if there are lifts or winches, speak to the manufacturer to get
the dimensioning information.
7.1.3 OVERLOAD CAPABILITY
The low overload means that if 110% of the rated continuous current (I
L
) is required for 1 minute every 10 minutes, the remaining
9 minutes must be approximately 98% of I
L
or less.
This is to make sure that the output current is not more than I
L
during the duty cycle.
Fig. 31: Low overload in N800A
The high overload means that if 150% of the rated continuous current (I
H
) is required for 1 minute every 10 minutes, the re-
maining 9 minutes must be approximately 92% of I
H
or less.
This is to make sure that the output current is not more than I
H
during the duty cycle.
N800A