Hyundai HYC3816, Руководство пользователя

Страница: 14 / 32

Page 14 Rev 2
6. OPERATION
6.1. Starting
6.1.1. Put machine on a flat surface with the fuel
and oil caps facing upwards.
6.1.2. Untwist and remove the fuel cap (1).
6.1.3. Put fuel/oil mix into the fuel tank.
6.1.4. Refit cap and fasten cap securely.
6.1.5. Untwist and remove the oil cap (2).
6.1.6. Put the required amount chain oil tank or to 80% of the full capacity.
6.1.7. Refit cap and fasten cap securely.
6.1.8. Wipe up any fuel or oil spillages on or around the unit.
6.1.9. Put the switch to the “I” position.
6.1.10. Continuously pump the priming bulb (1) until fuel
comes in the bulb.
6.1.11. Pull out the choke knob (2).
6.1.12. The choke will close and the throttle lever will then be
set in the starting position.
6.1.13. Push the front handle guard forward to activate the
chain brake.
6.1.14. While holding the saw unit securely on the ground, pull
the starter rope firmly.
6.1.15. When firing occurs, push in the choke knob and pull the
starter again to start the engine.
6.1.16. Pull up the front handle guard toward the front handle to release the chain brake. Then,
allow the engine to warm up with the trigger pulled slightly.
Before you start the engine, make sure the saw chain is not touching anything.
Make sure the chain brake is always activated each time you start the engine.
When restarting immediately after stopping the engine. Set choke in the open
position.
Once the choke knob has been pulled out, it will not return to the operating
position even if you press down on it with your finger.
When you wish to return the choke knob to the operating position, operate
the throttle trigger & throttle trigger lockout instead. NB It will push in but will
not deactivate.