Hyundai H-HV1-10-UI562, Инструкция по эксплуатации

Страница: 8 / 52

8.
Electric convector
EN
WARNING!
The power outlet should be rated at least 10A for models with a
maximum capacity of up to 2000 W and at least 12 A for models with a
maximum capacity of 2500 watt.
6. OPERATION
For models:
H-HV1-10-UI562
H-HV1-15-UI563
H-HV1-20-UI564
5. CONNECTING TO THE MAINS
1. Convector is designed for connection to the plug with single-phase ~220 V, 50 Hz.
2. Before connecting, make sure that the voltage is correct as speci ed on the nameplate with the
technical data of the device.
3. Convector when connected to the plug must comply with applicable electrical codes.
4. Electric outlet must be properly grounded. The receptacle must be rated for at least 10A.
Electrical plug and socket must always be kept dry to prevent electrical leakage. Regularly check
that the electrical plug is rmly connected to the outlet. Veri cation is performed in the following
order: Insert the mains plug into the socket. A er half an hour, turn o the convector and unplug
the power cord, check with the hand, whether the plug is not heated.
If the plug is heated to a temperature above 50 °C, in order to avoid damage, accidents, re, due
to poor electrical contact replace the socket with help of a specialist.
Floor installation
1. Carefully remove the heater from the package.
2. Make sure that the parts of the appliance have no remaining crumbles of packing foam plastic
or other debris.
3. Remove the two support legs from the packaging of the convector.
4. Turn the unit so that its bottom was in easy access.
5. Attach the support legs to the bottom of the device to the le and right sides so that the
fastening holes align with the holes on the xture.
6. Tighten the screws in the existing holes.
Fig. 6
1000 W
300 494 600
118 110 119
1500 W 2000 W