3
Product Overview
Radio Unit
Remote Speaker
Microphone
Connector
Power
On/Off Key
RF Antenna Connector
Power Interface
Accessory Connector
GPS Antenna Connector
Fan
Caution:
●
GPS antenna connector is for MD65X
mobile radio with GPS feature only.
●
Do not block the ventilation hole of
the fan.
●
Clean the fan regularly.
●
Do not stop the fan with hard objects
such as a screwdriver to avoid fan
damage.
●
Do not touch the fan blades when the
fan operates to avoid bodily injury.
Remote Speaker Microphone
For enhanced convenience, you may request your
dealer to program the TK, P1 and P2 keys as shortcuts
to certain functions. You may refer to the corresponding
Feature Book for more details.
Caution: The
TK
is programmed with
emergency feature by default (short
press: Emergenc y On; long press:
Emergency Off). It is programmable by
your dealer.
Power On/Off Key
PTT Key
TK Key
LED Indicator
LCD Display
Key
Key
Key
Key
Speaker
Key
Buckle
Installation
Instructions
Before you install the radio in a vehicle, be sure to read
the following instructions carefully:
●
The radio must work with a 13.6V±15% negative
ground electrical system only. And ensure to check
the ground polarity and voltage of the vehicle
power supply prior to installation.
●
Check how long the screws will extend from the
bottom surface of the radio before installation. Drill
the mounting hole cautiously to avoid damage to
the vehicle wiring and other parts.
●
Connect the antenna and power cord to the radio,
before you install it in the bracket. And make sure
the antenna and power cord are dedicated for
digital radios of the Company.
●
Install the radio with the mounting bracket supplied
by the Company, to avoid radio looseness in case
of accidents. The loose radio may cause bodily
injury.
●
Install the radio in a location where it
’
s easy to
reach the front panel controls.
●
Keep sufficient clearance at the back of the radio
for wiring.
●
Be sure to use the fuse with the same specification
for DC power cord upon replacement.
●
If there are any other device in the vicinity of this
radio, the distance between the antenna of this
radio and the antenna of such RF device shall be
no less than 10 meters.
Installation Tools
●
Drill
●
Cross head screwdriver
●
Hex socket sleeve (for 4.8
×
20mm self-tapping
screws assembling)
Installation Procedure
To install the radio, do as follows:
