Hyster J30XNT, Руководство по эксплуатации

Страница: 191 / 226

Service Brakes
WARNING
Loss of fluid from the brake fluid reservoir indicates a
leak. Repair the brake system before using the lift
truck. Replace the brake fluid in the system if there is
dirt, water, or oil in the system.
There is an indicator icon on the display panel for the brake
fluid level. The icon is illuminated as described in the
Model Description section of this manual. If the icon is illu-
minated during operation, the fluid in the reservoir for the
brake master cylinder is too low. Add brake fluid and check
for leaks. The reservoir is under the brake pedal and floor
plate. See
Figure 24 . Clean the area around the fill cap so
that no dirt enters the reservoir.
Check the operation of the service brakes. Push on the
brake pedal. The brakes must be applied before the pedal
reaches the floor plate. The brake pedal must stop firmly
and must not move slowly down after the brakes are
applied. The brakes must apply equally to both drive
wheels with no noticeable pull to either side.
Automatic Parking Brake
There is an indicator icon on the display panel for the Auto-
matic Parking Brake (APB). The icon is illuminated as
described in the
Model Description section of this manual.
If the APB is not applied and the operator leaves the seat
or turns the key or keyless switch to the
OFF position, an
alarm will sound for approximately 60 seconds. This is only
on manually applied parking brakes, not the Seat Activated
parking brake option. ALWAYS apply the parking brake
when leaving the seat.
Make sure the service brakes operate correctly before
checking the operation of the Automatic Parking Brake.
Check the operation of the APB. The Automatic Parking
Brake, when in good condition and correctly adjusted, will
hold a lift truck with a capacity load on a 15% grade [a
slope that increases 1.5 m in 10 m (1.5 ft in 10 ft)]. If park-
ing brake requires adjustment, notify service personnel.
Operator Presence System
Check the operation of the Operator Presence System
(OPS). Turn the lift truck power
ON while sitting in the seat.
Once lift truck power is ON , get up off the seat. If the OPS
is working correctly, a switch in the operator's seat will
Maintenance
189
Property of American Airlines