Hyster H40-60XT, Руководство по эксплуатации

Страница: 54 / 180

The load center of a load is determined by the location of
its center of gravity. The load center is measured from the
front face of the forks, or the load face of an attachment, to
the center of gravity of the load. Both the vertical and hori-
zontal load centers are specified on the Nameplate.
Loads should be transported while centered on the center-
line of the lift truck. The operator must know whether or not
a load is within the maximum capacity of the lift truck
before the load is handled.
Inspection Before Operation
WARNING
Report damage or faulty operation immediately. Do not
operate a lift truck that needs repair. A lift truck will
only do its job when it is in proper working order. If
repairs are required, install a tag in the operator's area
stating "DO NOT OPERATE" and remove the key from
the key switch if truck is equipped with key switch
option.
Checks With the Engine Stopped
Inspect the lift truck before use and every eight hours or
daily as described in the
Maintenance section of this
Operating Manual . Inspect more frequently if used in
severe operating conditions.
Before using the lift truck, make the following checks:
• Condition of forks, carriage, chains, header hoses, mast,
attachment, and overhead guard.
• Condition of wheels and tires.
• Seat belt fastens correctly.
• Seat is correctly fastened to its mounts. Hood is correctly
latched.
• Condition of the engine compartment. Ensure all surfa-
ces are free of oils, lubricants, fuel, and organic dusts or
fibers (paper, wood, cotton, agricultural grass/grain, etc).
Remove all foreign materials.
• Coolant level in the cooling system and condition of the
drive belts.
• Condition of the radiator and screen. Clean if necessary.
Operating Procedures
52