Hyster B218, Периодическое техническое обслуживание

Страница: 12 / 26

Maintenance Schedule 8000 SRM 1009
1. BREATHER CAP
2. HYDRAULIC OIL RESERVOIR
Figure 4. 24-Volt Hydraulic Reservoir
Lifting Mechanism
WARNING
DO NOT put any part of your body in or
through the lift mechanism unless the forks
are completely lowered, the key is removed,
and the battery is disconnected.
Always wear the proper protective equipment
including eye protection and petroleum-resis-
tant gloves when handling hydraulic oil. Thor-
oughly wash oil from exposed areas of skin as
soon as possible.
Never check for leaks by putting hands on
hydraulic lines or components under pressure.
Hydraulic oil under pressure can be injected
into the skin.
1. Raise the forks slowly without a load. Check for
smooth operation and mechanical interference.
Mechanical interference is caused by damaged
or worn linkage or shafts, or by incorrect adjust-
ment of the tension rods.
2. Check for damaged or worn linkage bushings or
shafts.
3. Check for missing or loose shaft pins.
4. Check load wheels and support bearings, shafts,
and shaft pins for wear, damage, or missing
parts.
Controls
WARNING
If any function does not operate or operates in-
correctly, report the faulty operation immedi-
ately. DO NOT operate the lift truck until the
problem is corrected. Put a DO NOT OPERATE
tag on the control handle. Remove the key and
disconnect the battery.
Perform the following checks in an area that is
clear of other personnel or equipment.
1. Check the operation of the key switch. Functions
should not operate with the key switch in the
OFF position, except the steering. Turn the key
switch to the ON position. Lower the control
handle to the operating position.
The horn,
hydraulic system, traction system, and brake
should now be operational.
2. Check the operation of the brake switch. Release
the control handle to allow it to return to the ver-
tical position. Move the speed/direction control
without lowering the control handle. The trac-
tion system must not operate.
3. Check the operation of the speed/direction con-
trol.
Lower the control handle to release the
brake. Slowly rotate the speed/direction control.
The lift truck must accelerate smoothly. Rotate
the control in the opposite direction.
The lift
truck must stop smoothly and then change direc-
tion. The control must return to the OFF posi-
tion when released.
4. Check the operation of the lift and lower func-
tions. Push the lift button and then the lower
button. Check that the forks raise and lower.
8