Installation, Operation, Repair And Parts Manual
7/05
Description
Series 5300C-X, 5321C, 5322C and 5324C
Small Twin® Piston and Plunger Pumps
Form L-0200P
The following special attention notices are used to notify
and advise the user of this product of procedures that
may be dangerous to the user or result in damage to the
product.
NOTE: Notes are used to notify of installation, oper-
ation, or maintenance information that is important
but not safety related.
CAUTION: Caution is used to indicate the presence
of a hazard, which will or can cause minor injury or
property damage if the notice is ignored.
WARNING: Warning denotes that a potential hazard
exists and indicates procedures that must be fol-
lowed exactly to either eliminate or reduce the haz-
ard, and to avoid serious personal injury, or prevent
future safety problems with the product.
DANGER: Danger is used to indicate the presence
of a hazard that will result in severe personal injury,
death, or property damage if the notice is ignored.
Safety Information
SERIES 5321C & 5322C
Cast Iron Small Twin
Plunger Pump
Max. Flow Rate:
........................2.2 gpm
Max. Pressure:
........................1000 psi
Max. Speed:
............................1725 rpm
Ports:
................................1/2" NPT inlet
1/2" NPT outlet
Max. Operating Temp.
................180o F
SERIES 5300C-X
Cast Iron Small Twin
Piston Pump
SERIES 5324C
Cast Iron Small Twin
Piston Pump
Max. Flow Rate:
........................2.9 gpm
Max. Pressure:
..........................800 psi
Max. Speed:
............................1725 rpm
Ports:
................................1/2" NPT inlet
1/2" NPT outlet
Max. Operating Temp.
................140o F
Max. Flow Rate:
..................1.5, 2.0, 2.5
and 3.0 gpm
Max. Pressure:
..........................500 psi
Max. Speed:
............................1725 rpm
Ports:
................................1/2" NPT inlet
1/2" NPT outlet
Max. Operating Temp.
................140o F
DANGER: DO NOT pump flammable or explosive
fluids such as gasoline, fuel oil, kerosene, etc. DO
NOT use in explosive atmospheres. The pump
should be used only with liquids compatible with the
pump component materials. Failure to follow this
warning can result in personal injury and/or proper-
ty damage and will void the product warranty.
A pressure relief device, such as an unloader, relief
valve or balancing regulator must be installed on the
outlet side of the pump. Failure to do so could
result in personal injury and/or void the warranty.
•
Be sure all exposed moving parts such as shafts,
couplers and adapters are properly shielded or
guarded and that all coupling devices are securely
attached before applying power.
•
Hollow shaft pumps mounted directly onto power
shaft must be prevented from rotating with the power
shaft by means of a device such as a torque arm.
Pump must float freely on the power shaft and must
not be tied rigidly to equipment on which it is mount-
ed.
AG_200P_0705.qxp 6/30/05 3:36 PM Page 1
Содержание SERIES 5300C-X
Страница 18: ...18 NOTES...
Страница 19: ...19 NOTES...