Hypertherm SmartSYNC 059719, Руководство по процедурам

Страница: 78 / 98

Mini Machine and Robotic Torch Part Replacement Procedures
6
78 810460 Service Parts and Procedures SmartSYNC
Figure 15 – 90° and 45° robotic torch components
Disassemble the mini machine or robotic torch
This procedure shows how to fully disassemble the torch. This includes removal of all of the torch
components from the right side of the torch shell, and how to disconnect all of the wires.
It is not always necessary to fully disassemble the torch. Only remove and disconnect the
components and wires that you must for each replacement part.
Before you begin
Complete the procedures in Prepare to Do the Part Replacement on page 37:
1. Disconnect the power from the cutting system on page 39.
2. Remove the Hypertherm cartridge on page 39.
3. Put a clamp on the torch lead on page 40.
4. Remove the left side of the torch handle or shell on page 41.
5. Get a photograph of the torch on page 41.
7
8
1
2
3
4
5
6
5
This example shows a 90° torch.
The components are the same
for the 45° torch.
45° torch
4
1 Torch lead
2 Torch body
3 RF torch PCB
4 Cap-sensor switch
5 RF wires and clip
6 RF torch PCB wires and connector
7 Pilot terminal screw
8 Gas fitting