Hypertherm HyPrecision 50S, Руководство оператора

Страница: 100 / 202

100 HyPrecision 50S/60S/75S Operator Manual 808690
5 – Preventive maintenance
Preventi
ve maintenance
Disassemble the intensifier

Refer to the
Intensifier parts
section on page 127 for part numbers. Refer to page 149 for ordering
information.
Remove the output adapter and the high-pressure poppet assembly

The high-pressure poppet seat can cause cracks, erosion marks, or indents in the output adapter.
Required parts, tools, and materials
Clean, lint-free towels
Isopropyl alcohol
1-inch open-ended wrench
15564 6-inch cotton-tipped applicator
1. Use an open-ended wrench to loosen the output adapter. Remove the output adapter from the check valve.
2. Use a cotton-tipped applicator to guide the high-pressure poppet seat out of the check valve. Tap the output
adapter gently on a wooden or other soft surface to eject the poppet from the output adapter.
3. Clean each part with a lint-free towel and isopropyl alcohol. Examine all parts for deterioration, corrosion, or
damage.
Repair or replace parts identified in the preventive maintenance schedule or if the parts show
deterioration, corrosion, or damage.
Examine parts that are being replaced to identify wear patterns or damage that can indicate other
problems
If any of the poppet parts are damaged, replace all 3.
Service Interval
Replace the high-pressure poppet assemblies After every 1,000 hours of operation
Replace the output adapters After every 6,000 hours of operation
Do not use soap, detergent, or solvents.
1
2
3
4
1 High-pressure poppet seat
2 High-pressure poppet
3 High-pressure poppet spring
4 Output adapter