Hypermedia HG-3000, Руководство по эксплуатации продукта

Страница: 13 / 122

Hypermedia Systems
Hardware and Installation
Release 5.3 (June 2013)
3
1.2 Safety Information
The Hypermedia Gateway works with a nominal mains supply voltage of 110–240
VAC. Hazardous voltages are present inside the equipment. Some parts may also
have high operating temperatures.
To avoid injury and prevent equipment damage, observe the following safety
precautions:

Installation, service, and maintenance of the Hypermedia Gateway should be
done by qualified technicians only.

Do not connect the Hypermedia Gateway to any power source other than the
indicated nominal source.

The power supply cord must be connected to a socket with a valid ground. This
equipment should only be used in buildings with proper safety ground.

When connecting the equipment, first, ensure that the ground connection is
connected to the rack ground or building ground.

When disconnecting the equipment, disconnect the ground connection last.

Opening the housing may be dangerous and invalidates the warranty. Only a
qualified technician should open the housing. Before opening, disconnect the
power cable from the equipment.

The Hypermedia Gateway complies with all necessary safety standards.
Equipment connected to the Hypermedia Gateway must also comply with the
applicable safety standards.

The packaging is designed to protect against mechanical damage and should be
stored. Do not ship equipment unless it is properly packed in its original
wrapping and shipping containers.

Make sure that the equipment top and bottom are not blocked to air movement.
Leave 1U under and on top of the equipment for proper ventilation.

Do not operate the Hypermedia Gateway in close proximity to potentially
hazardous areas. These include areas such as, but not exclusively, fuel stations,
fuel depots, chemical works or during blasting.

The operation of radio transmitters, which includes cellular engines, can impair
the function of medical devices that have not been properly shielded. Ask the
advice of your doctor or the manufacturer of the medical device.

To avoid moisture condensation, allow time for the unit to adapt to the ambient
temperature before switching it on.