Hydronix Hydro-Control VI, Руководство оператора

Страница: 31 / 88

Chapter 6 Editing Recipes
Hydro-Control VI Operators Guide HD0456 Rev 1.7.1 31
Recipe parameter Description
Wet Mix Time When using Auto-track control, this is the amount of time that the
Wet Mix must be within the Wet Mix Deviation below to continue.
If the sensor signal has not stabilised within this window by the end
of the Wet Mix Time, the system will prompt the operator to
continue regardless of whether it has stabilised or not.
Wet Mix Deviation This is the maximum deviation that the sensor signal must be within
in order for the system to continue.
Using the Next button gives Page 3 of the recipe editor screen.
Figure 13: The recipe editor screen (page 3)
1.6
Calculation Mode Settings
Recipe parameter Description
Pre-wet Moisture Offset 1
Pre-wet Moisture Gain 1 These are the calibration coefficients for the pre-wet phase of the
recipe. These define the relationship between the amount of
moisture in the batch and the unscaled sensor value. These are
automatically calculated when you calibrate a recipe.
Moisture Offset 1
Moisture Gain 1 These are the calibration coefficients for the recipe. These define
the relationship between the amount of moisture in the batch and
the unscaled sensor value. These are automatically calculated
when you calibrate a recipe.
Moisture Offset 2
Moisture Gain 2 These are the calibration coefficients for the recipe with the
admixture in. These are automatically calculated when you
calibrate a recipe using the two step preset method.
Use Pre-wet value for main
water
If enabled the Hydro-Control VI will use the reading measured at
the end of the pre-wet mix rather than the dry mix to calculate how
much water to add in the main water addition