Hydronix Hydro-Control VI, Руководство по установке

Страница: 42 / 104

Commissioning Chapter 4
42 Hydro-Control VI Installation Guide HD0455 Rev 1.9.0
6 Sensor Configuration
With a sensor connected, the measurement parameters and settings can be changed by using the
sensor configuration pages which area accessed from the main screen pressing the menu button
and then the sensor configuration button . This section briefly describes the
options available in the screens. For more detailed information on the parameters available, refer
to the relevant sensor user guide.
6.1
The Sensor Configuration Screen – Page 1
Figure 28: The sensor configuration screen - Page 1
Sensor Identification
This section shows the Board Set identifier, the Node identification number on the RS485
network and allows a sensor name to be set.
Material Calibration
This section shows the current material calibration that has been downloaded to the sensor.
This is updated when the recipe in the Hydro-Control VI is changed. The current measurement
mode selected for the recipe is also displayed (only with compatible sensors).
Analogue Outputs
This section allows the setup of the Analogue Outputs on the sensor to be adjusted. As the
Hydro-Control VI communicates with the sensor using the RS485, the analogue outputs can be
used independently of the main control itself. As the material calibration is downloaded to the
sensor when the recipe is changed, if the analogue output is set to output Filtered Moisture
then the analogue output will follow the Hydro-Control VI moisture value.
Averaging
This section configures the Averaging function in the sensor. This is not generally used in mixer
applications.
If any settings are changed then they should be downloaded to the sensor using the ‘Write To
Sensor’ button.