HydroLogic EvolutionRo, Руководство пользователя

Страница: 6 / 16

55
STEP 2:
Put a thin layer of included lube on the O-rings
of the three housings. Be sure to completely cover
the O-rings but save some for STEP 9. Housing
can then be installed, screwed in clockwise, hand-
tight (even if empty, required for carbon flush.
There’s no need for the flange on the
bottom of the housing to
come in contact with the
flange on the manifold.
Apply lube here on
all three housings.
STEP 1:
Install carbon filter.
The filter can only be installed in
the manifold in the position shown.
Note that the O-ring is making the
seal. The other two openings in the
manifold are for the membranes.
If starting for the first time
DO
NOT install membranes; complete
installation without them and
run for 10 minutes to flush
the carbon. If you are
replacing the carbon filter,
YOU MUST REMOVE
MEMBRANES FIRST.
Afterwards, go back to STEP
9 to install the two membranes.
IMPORTANT: BEFORE YOU START
To ensure optimal efficiency, the carbon filter
MUST BE FLUSHED
FOR 10 MINUTES, PRIOR TO MEMBRANE INSTALLATION
. To do
this, follow the steps below but DO NOT install the membranes, only the
carbon filter. After the steps are complete, run the system for 10 minutes.
Once the flush is complete, the system is ready to return to STEP 9 for
membrane installation. Flushing the carbon filter is extremely important
and must be done on startup or anytime the carbon filter is replaced.
STEP 3:
Lube the O-rings on each
of the 3 elbow connector
fittings and push them into
the corresponding ports
on the manifold as shown.
The back of each elbow connector
fitting has a symbol that corresponds
to the symbol next to the manifold
ports.
STEP 4:
Install the manifold lock bar clip by matching
symbols on the clip to symbols on the manifold
(square to square, arrow to arrow).
INCLUDES