background image

Landscape Lighting

IMPORTANT: This product requires a 12V AC or DC Power 
Supply and Power Cable (not included). For maximum lighting 
control and efficiency, we recommend using the Hydro-Rain

®

 

3-Station LED Landscape Light Controller/Transformer 
(06700). Power cable should be 12G-16G outdoor landscape 
lighting wire. 
WARNING: 
•  Read all instructions thoroughly before use.
•  Do not install or connect electrical wires with wet hands.
•  For low voltage landscape lighting systems only.
•  Do not drive over electrical cables.
•  Main low voltage cable (power supply cable) to be buried 

less than 6 inches beneath the ground surface.

•  Do not submerge product in water.
•  This product for use only with a 12V power supply.
•  WARNING - Risk of Electric Shock. Install all luminaires   

10 feet (3.05 m) or more from a pool, spa, or fountain.

ASSEMBLY AND INSTALLATION
1. At desired installation location, loosen the ground and 

insert the mounting stake. If using a hammer, place a 
board on top of stake to avoid damage to the stake. 

2. Clear dirt and debris away from wire slot in top of stake.
3. Assemble the pathlight by screwing the light shade  

onto the stem.

4. Lay 12V wire cable from light into the stake’s wire slot 

and screw stem into the stake. Do not overtighten. If light 
assembly needs straightening, gently push or pull on the 
stake only.

CONNECTING TO POWER SUPPLY WIRE
CAUTION:
 Use shielded power cable for outdoor use  
in the following sizes: SPT-2W 16G, SPT-2W 14G,  
SPT-2W 12G.
IMPORTANT: Turn off power before installing or removing 
connector. Product to be used in accordance with local and 
national codes.
1. Strip light wire ½ inch from ends.
2. Cut power supply cable and strip all wires on both sides  

½ inch from ends.

3. Straighten any frayed strands.
4. Place one wire from each end of the power supply cable 

together with one of the light wires with ends of insulation 
even. See figure 1. (It does not matter which power supply 
cable is connected to which light cable, as light cable is  
not polarized.)

5. Twist connector onto wires pushing firmly until hand-tight.  

Do not over torque.

6. Do not reuse connectors, as they may lose sealant.
7. Repeat steps 4-6 with the remaining 3 wires (1 wire from each 

end of the power supply cable and the remaining light wire). 
See figure 2.

Hydro-Rain

®

915 Overland Street

North Salt Lake, UT 84054 USA

www.hydrorain.com

1-888-493-7672

[email protected]

PN 06701-24 rA

Stem

Shade

Stake

Wire slot

Power Cable

Light Cable

Figure 1

Figure 2

MODELS: 

HRL-BKP1-LED-3W (06701)
HRL-BRP1-LED-3W (06703)

Отзывы: