Pro Mist 35 User Manual
www.HydroMistUSA.com
16
7.2
Procedure for Oil Change
NOTE: The misting pump comes pre-filled with oil.
Oil must be changed after first the 50-hour operation mark,
and after every 250-300 hours of running.
Use ISO 68 oil or equivalent, available from HydroMist:
ISO68 Pump Oil, 21oz. bottle: Part# F02-06-001
Always power off the machine and disconnect power before
performing any maintenance or inspection.
—
Irregular maintenance and failure to change the oil regularly
will cause damage to the machine parts and/or shorten the
service life.
—
When changing the oil make sure to remove the old oil
completely. Too much old oil can affect the quality of the new
oil.
—
Only change the oil with the pump on a level surface.
—
Do not change hot oil. Pump operation increases the oil
temperature to a dangerous level and can cause severe burns.
7.2.1
Purge pressure and water from the misting system by opening the ball
valve on the pump outlet.
7.2.2
Remove the water supply hose and high-pressure misting hose
connections.
7.2.3
Unplug the pump from the power supply.
7.2.4
Remove the pump cover by loosening the eight pump cover screws.
7.2.5
Check inside the bottom of the machine to see if there is any oil leakage
from the pump body. Clean up any oil leaks or spills so that a leak can be
detected.
7.2.6
The maximum oil capacity is 5 oz. (
≈
145 ml).
