Hydro International Hydro-Logic Flexi Logger 300Ex, Руководство пользователя

Страница: 15 / 74

Hydro-Logic
®
Flexi Logger 300Ex
User Manual
22 August 2018 Page 15 of 74
Note that the internal clock is stopped when the logger is switched off, but the
configuration and stored data are preserved. You need to
reset the logger clock
after it is switched on so that data from the sensor is correctly time-stamped.
This can be done either by
Resetting logger clock with Timeview or Resetting the
logger clock with Harvest
Connecting to Timeview
With the logger on, press and hold the dial-out button (1) until you see a yellow
flash on the LED. The dial-out can also be triggered with a strong magnet near
the reed switch (2), without the case being opened.
The enclosure should never be opened in the Hazardous Area.
The logger will then begin a series of steps to call out to Timeview. Progress can
be followed using the
Status LED flash patterns , or you can just wait for a few
minutes until the red, blue and green flashing has stopped and the logger has
gone back to a
single blue flash every 2s .
Now see Finding your data on Timeview
– you should be able to see that your
logger has connected successfully.
If the mobile data signal is poor, the logger will try several times to transfer data
to Timeview, so there is no need to press the dial-out button more than once.