Hydro-Flux FlowBright, Инструкция по эксплуатации

Страница: 15 / 16

P a g e | 15
Troubleshooting
Symptoms Possible Cause Check
Light will not
activate
No signal from
remote
➢
Remote control may be out of
range.
➢
Low battery
Insufficient flow to
light turbine
➢
Check if filter is turned on.
➢
Check pre-filters.
➢
Possible pump de-prime or
intermittent flow.
➢
By-pass gates set incorrectly –
gate open too much. Please see
gate chart.
➢
Possible restriction at turbine inlet.
➢
Flow to install inlet not optimised.
See Flow Determination
Light operates but
poor light output
Remote has poor
response –
intermittent
operations
Low remote signal
strength
➢
Remote control may be out of
range.
➢
Low battery
➢
Metal objects in the area are
causing signal interference.
Back-pressure
raised in system
Filter blockage
➢
Backwash or clean filter
Flow through
turbine too high
➢
Check by-pass gate setting, as you
may need to change to a more
open setting.
➢
Remove FlowBright from pool,
check turbine cavity, inlet, and
remove any potential debris.
Turbine blockage
Excess noise from
light assembly
Turbine speed too
high
Excess bearing
wear
Turbine damaged
➢
Contact pool specialist