Page 12
2.5.9.
WARNING
–
CHARGERS CAN IGNITE FLAMMABLE
MATERIALS AND VAPORS. DO NOT USE NEAR FUELS, GRAIN DUST,
SOLVENTS, OR OTHER FLAMMABLES.
2.6.
TRANSDUCER PRODUCT USER SAFETY
INSTRUCTIONS
3.6.1.
WARNING:
The Transducer emits powerful vibratory energy
–
DO NOT place the Transducer against your skin or body, nor touch the
Transducer while the Transducer is powered
.
3.6.2.
WARNING:
Locate/route all cords where they will not be
tripped over or damaged by vehicles or equipment with cutting blades
such as lawn mowers and hedge clippers and away from vehicle traffic
to prevent being driven over.
If you have water animals (beavers,
minks, nutria, otters, muskrats, turtles, etc.) in your water system,
additional cable protection is recommended such as a nylon or
polyester braided sheath from the surface down to about 2 meters (6
feet) depth.
3.6.3.
WARNING:
If installing underground electric utility power to a
receptacle near a body of water such as a pond, lake, pool or reservoir,
an armored cable run through conduit must be used to minimize risk of
damage and installed in accordance with Country, State and Local
regulations.
3.6.4.
WARNING:
Never connect or disconnect Transducer and its
Power Cable to or from the AC Power Supply or the Solar DC power
Supply while they are powered on. Doing so will cause the contact pins
to arc and disfigure causing potentially non-warranty damage to the
connector’s
connection pins.
3.6.5.
Do NOT attempt to force connections. Each connector only fits in one
way by aligning the letters or notches described, then turn the outer
ring on connectors until it clicks and tightens in place.
