HydraMaster Boxxer 318HP, Руководство пользователя

Страница: 47 / 124

4-7: Operating Instructions
SHUT-DOWN PROCEDURE
1. Flush clean water through the chemical system for 10 seconds. Turn the “CHEMICAL
PUMP” valve to “OFF.”
2. Cool the truckmount down by turning the “TEMPERATURE CONTROL” dial to the
lowest position (counter-clockwise). Spray the cleaning wand into the vacuum hose
for 3 - 5 minutes. The chemical is now flushed from the truckmount, hoses and
cleaning tool.
3. Remove the vacuum hose.
4. Lubricate the blower to prevent it from rusting internally.
a. Allow the unit to run for a few minutes with the vacuum hose disconnected in
order to remove moisture from the blower.
b. Cap off the inlet(s) to the Recovery Tank.
c. Spray a HydraMaster-recommended spray lubricant into the “BLOWER LUBE
PORT” for about 5 to 7 seconds while the unit is running (see Figure 4-2).
d.
Allow machine to run additional 2 to 5 minutes under load to flush off lubricant.
e. Uncap the inlet(s) and run the unit for another minute to allow the blower to cool
down.
5. If freeze guarding is necessary, perform the procedure at this time. See section 5,
the Freeze Guarding section in this Owner’s Manual.
6. Return the engine throttle to the “IDLE” position.
7. Turn the key to “OFF.”
8. Drain the water box using the valve.
9. Drain the Recovery Tank into an appropriate location.
In accordance with the EPA, state and local laws, do not dispose of water into
gutters, storm drains, streams, reservoirs, etc.
10.
Perform daily maintenance as specified in section
5 of this Owner’s Manual.