Hydac SMU 1000, Руководство по эксплуатации

Страница: 31 / 48

SMU1000 Resetting
HYDAC FILTER SYSTEMS GMBH en(us) Page 31 / 48
BeWa SMU1000 34x 3614430a en-us 2012-03-13.doc 2012-03-13
Resetting
You can reset the system using the PC in the online mode or via the menu of the
controller. To do so, select the menu item in the control configurator or in the menu
of the controller.
Reset commands are described in detail below
Reset warm

The program is stopped.

The non-remanent variables are initialized; the "retain" variables are retained.

The program can be restarted.
Reset cold

The program is stopped.

All variables are initialized.

The program can be restarted.
Reset original

The program in the working memory and the boot project in the system memory of
the controller are deleted.

With a memory card plugged in:
-
All project-specific files on the memory card, the operating system, and
the boot project are deleted.
-
All user-specific files and the startup.ini file remain unchanged

The controller is set to the NOT READY condition.
Resetting to the factory settings (factoryset)
Using the browser command "factoryset" or the controller's menu item <SYSTEM l
WERKSEINSTELLUNG>, a "Reset original" is performed (see section "Reset
original").
In addition, the Startup.ini file on the memory card and the system parameters in the
controller are deleted. After a start the controller works with the STARTUP data
again. The interfaces are initialized with their default values.