HYDAC International FMM-O-M, Инструкция по установке и обслуживанию, Страница: 23 / 28

FluidMonitoring Module – FMM-O-M Removing the FMM from the hydraulic
t / h td
HYDAC FILTER SYSTEMS GMBH en(us) Page 23 / 28
MoWa FMM-O-M 3492448a en-us 2010-12-15.doc 2010-12-15
Removing the FMM from the hydraulic system/shutdown
To decommissioning the FMM, proceed according to the following steps:
1. Remove the electric plug to the CS1000 and AS1000.
2. Depressurize the system.
3. Remove the connected hoses/piping from the FMM.
4. Remove the FMM.
Disposing of the FMM
Dispose of the packaging material as appropriate for your area.
When decommissioning and/or disposing of the FMM, observe all local guidelines
and regulations pertaining to occupational safety and environmental protection. This
applies in particular to the oil contained in the unit, to components coated in oil and
to electronic components.
After disassembling the unit and separating the various materials, reuse them or
dispose of them properly in accordance with local regulations.