Hyd-Mech V18APC, Руководство пользователя

Страница: 61 / 73

4.8
For Electrical Schematics and Components Parts List
See PDF on Attached CD
DT (Device Tag)
The remainder of the components in the control panel are labeled and are referred to in the documentation under the DT
heading. For example:
DT, CR4 is the control relay labeled CR4.
DT, LS2 is the limit switch for Head Advance function.
DT, MS 1M is the contactor labeled MS 1M.
DT, SS4 is the selector switch for Head Control.
Page and Row Numbers
In each title block of the project (electrical documentation) there are 2 headers, which are:
1. Page. This refers to the current page number
2. Pg. This refers to the total number of pages in the entire project and is for internal HYD·MECH use only.
On each Page there are a row of 4 digit numbers on the left of the page.
For example, Page 14 shows the numbers from 1400 to 1439.
The first 2 digits refer to the page number, which in this case is page 14.
The latter 2 digits refer to the row number, which in this case are from 00 to 39.
Whenever the electrical schematic shows a target to another page then the method described above should be used to
locate the component, device, wire etc.
The same format applies when reading the wire list or cable list as the page and row number are included on the list.