Hyd-Mech S-20 A, Руководство пользователя

Страница: 27 / 80

2.11
SINGLE CUT MODE
BLADE SPEED 0 SFM
LENGTH 0”
JOB # - IS PAUSED
TO RESUME PRESS CYCLE START
7. When the cut is completed, the head will rise to the head up limit switch, the blade will stop and the
display window will reset for the next cut.
8. To cut another piece, repeat steps 2 through 6.
NOTES:
1. To pause the SINGLE CUT CYCLE, press the CYCLE PAUSE button. The CYCLE START button will
EHJLQWRÀDVKDQGWKHVFUHHQZLOOLQGLFDWHDSDXVHGFRQGLWLRQ$OOPRYHPHQWVZLOOLPPHGLDWHO\FHDVH
except blade will continue to run. To continue the cycle, press CYCLE START.
2. To cut multiple pieces, switch to AUTO MODE and follow the automatic procedures.
3. Whenever a new job or new material is being loaded for production, the head up limit switch should be
properly set to clear the material positioned for a trim cut and the front vise should be closed (in MANU-
AL MODE).
AUTOMATIC OPERATION
To enter AUTO MODE, the FIXED VISE must be in the closed position and the LED on. When the AUTO
MODE key is pressed, the red indicator will come on. The screen will change to the JOB display
window as shown below and will be ready for editing or starting a new job. All manual functions will
be disabled.
PROCEDURE FOR EDITING OR STARTING A NEW JOB IN AUTO MODE
1. In AUTO mode, key in a job number from 0 to 999, the number of pieces to be cut, the number of
pieces already cut, and the length, pressing enter after each value. If the number of pieces cut equals
or exceeds the number required, the cycle will not start. If the job number has previously been pro-
grammed, the number of pieces, length, and number cut will be displayed. To navigate through the
values, use the cursor keys. The values displayed may be edited by using the numeric keypad and
pressing enter. The job will then be stored in memory with the new values.
The job is now ready to start to run or other jobs can be programmed at this time. To run a certain job, press
the QUEUE key and then CLEAR to clear the QUEUE. Move the cursor to the 1
st
job and key in the desired
JOB #.