Hyco Ara IN30T, Инструкция по эксплуатации товара

Страница: 13 / 16

7. Troubleshooting
Problem Likely Fault(s) Solution
The heater will not reach the
target temperature (water is too
cold)
Flow rate is too high Ensure an appropriate flow
restrictor is fitted to the outlet
(1.6 l/min restrictor supplied
with unit)
The heater will not reach the
target temperature (water is too
cold)
A target temperature has been
set which is outside the
performance parameters of the
unit
Review the temperature
performance information in the
operation section and select an
achievable target temperature
or if left the unit will get as close
as possible to the target
The control lights illuminate
but the heater does not display
any temperature when water is
flowing
Flow rate is too low Ensure a minimum flow of 1.2
l/min
The control lights illuminate
but the heater does not display
any temperature when water is
flowing
Pressure is too low Ensure a minimum of 0.05 Mpa
No lights on the heater No electrical supply Check electrical supply
No lights on the heater Heater not switched on Switch on using the bottom on/
off touch screen
No lights on the heater No water flowing through the
heater
Turn on/ open the tap
No lights on the heater Unidentified issue Contact Hyco for further support
Can’t adjust the temperature
setting
Water is not flowing through the
heater
Turn on/ open the tap
Water is too hot Temperature selection is too
high
Reduce the target temperature
setting to the desired
temperature
13