T
HIRD
P
ARTY
A
CCESSORIES
To further support the operation of E-33A-100701 loudspeaker, several third party accessories can be used such as:
1.
Loudspeaker Stand
Please make sure the loudspeaker stand is able to support up to 27 kg (60 lbs). The base dimension should
not be too small. Example: Argosy X-Stand.
2.
Vibration Isolator
Due to the low frequency reproduction capability of E-33A-100701, a vibration isolation between the
loudspeaker and the stand is highly recommended. Example: Auralex Mopad-XL, IsoAcoustics L8R430.
3.
Power Strip with on/off control
The amplifier is not equipped with on/off switch. It is highly recommended to turn off the amp when it is not
used. A power strip/conditioner/surge protector with on/off switch is highly recommended. Example: Furman
product, SurgeX product.
4.
Level control
The amplifier is always set a unity gain. A passive or active level control is recommended. Example: SM Pro
Audio Nano Patch+ (passive), Mackie BigKnob (Active), Coleman various level control products.
U
NPACKING AND
P
ACKING
Due to the size and weight of the loudspeaker, it is important to follow the following procedure/precautions while
unpacking:
1.
Never try to lift the inner box from the outer box or lift the loudspeaker from the inner box.
2.
Open one side of the box and flip the opening to face the floor (open end rests on the floor). Remove the
outer box by lifting it.
3.
Do the same for the inner box: open one side of the box and flip the opening to face the floor (open end rests
on the floor). Remove the inner box by lifting it.
4.
To ease the process, loose foams or other accessories can be removed prior to flipping the opening.
5.
Due to the weight, it is wise to get a second person help to lift the loudspeaker.
If you need to repack the unit for shipment, the loudspeaker has to be prepared before placing it to the inner box. The
first step is standing the loudspeaker vertically so the 10in woofer is on the top as shown in the picture below.
The edge protection should be placed as shown in the picture, which creates
an air gap for all of the components. After all foams are taped, insert the box
from the top and then flip everything. Fill in the rest of the gaps using the
foams and edge protection. Seal the inner box and add the additional edge
protection before placing it to the outer box. When the box is moved/rotated,
no moving part should be heard from inside the box.
Warnings: small air gap in the front of the face/components are required to
avoid damage during shipment.
Содержание E-33A-100701
Страница 1: ...USER GUIDE HX E 33A 100701 ...
