HWR InoFlex VF016, Руководство по эксплуатации

Страница: 30 / 53

4
Operation
Page 4-22
InoFlex
®
VF016 - VF026
© Copyright
Edition C HWR Spanntechnik GmbH
EN
4 O
PERATION
4.1 G
ENERAL INFORMATION
In this chapter you will find information on how to operate the InoFlex
®
cen-
tering vice.
Note
Also make sure to comply with the regulations and policies of the operating
company (e.g. regarding personal protective equipment (PPE)).
Attention
In addition, observe the operating instructions of the machine tool in which
the centering vice is installed.
4.2 P
REPARATIONS
Step 1 Check to make sure that the centering vice is properly installed
on the machine tool.
Step 2 Make sure that a functional test was carried out (see chapter
3.5).
4.3 C
LAMPING THE WORKPIECE
Attention
Make sure the machine tool is in proper working condition before turning
on the machine and before operation of the centering vice.
General hazard
If the max. speed of the milling-turning center is higher than the max.
permissible speed of the centering vice then a speed restrictor must
be installed in the machine.
Excessive operating speed of the centering vice and therefore exces-
sive centrifugal force must never be allowed. Otherwise there is a risk
that the workpiece is not clamped properly.
Step 1 Clamp the workpiece with a torque wrench and by turning the
spindle (1).
Note
Pay attention to the maximum tightening torque of the spindle (1) (see
marking on the upper housing and table 7-5 on page 7-36).
General hazard
An unsafely clamped workpiece increses the risk of accidents by fall-
ing out.