HD-SDI IR D&N DOME CAMERA
SK-D302IR(D)/HD21
MANUAL
◐PRECAUTION
◐FEATURES
1. Do not install the camera outdoors.
2. Choose an ideal location for the camera, since a camera unit must
be protected against vibration.
3. Be careful not to scratch the camera unit, especially lens or dome cover.
4. Use the camera within the temperature(-45℃ ~ +50℃).
5. Avoid any direct sun light toward the lens.
6. Use the AC adaptor 12V DC, 600mA regulated.
Dual voltage product can use 24V AC, 600mA adaptor.(option)
1. 1/2.9" Sony CMOS sensor
2. Full HD Resolution
3. DAY & NIGHT Function
4. WDR (Wide Dynamic Range)
5. 3D DNR Function
6. Privacy mask function 28 area
11. This camera is incredibly flexible to install with its 3-axis camera
construction, which makes the camera ceiling, wall or slope
mountable
12. 25M range visible in total darkness with 24pcs of IR LEDs.(Indoor)
7. On Screen Display menu
8. Intelligent motion detection 4 area
9. Output : HD-SDI/CVBS
10. Protocol RS-485 : PELCO-P, PELCO -D (Option)
If the product is to be put out of operation definitively,
take it to a local recycling plant for a disposal which
is not harmful to the environment.
4. Camera angle adjustment
:
(1) Pan adjustment
(2) Tilt adjustment
(3) Roll adjustment
: Grasp the disk of camera and then adjust
direction to the right or left(-180 ~ 180 )
: Grasp the LED cover of camera and then adjust
direction to the up or down(6 ~ 90 )
: Grasp the camera holder and then rotate
(-178 ~ 178 )
˚
˚
˚
˚
˚
˚
◐ DIMENSION
◐ ASSEMBLY
<Caution>
If you try to adjust the camera out of limited angle, it might cause
troubles and damage to camera.
DOME COVER
LED COVER
SCREW
CAMERA MODULE
SCREW
CABLE
DISK
BASE
CONTROL PCB
PUSH BUTTON
HARNESS
SCREW
DUAL POWER PCB
◐ HOW TO INSTALL
1. Opening the dome
2. Removing the dome
3. Camera installation
:
:
:
Pushing the latch button.(Remove the protection
sheet after installing.)
Lift the dome. When you push the latch
button, it is unlocked and you can lift the dome.
(1) Fix the camera set with the supplied screws on ceiling or wall mount.
If you don't use supplied screws, the camera may fall off.
(2) Please refer to '4. Camera angle adjustment' regarding adjust
camera angle.
(3) Lens adjustment(Vari-focal Lens only)
After opening the LED cover,
① By turning the "Tele-Wide" knob,
you can access a range of focal
lengths within specified limits.
② Since then, by turning the "Near-Far"
knob, you can set the focus toward
the wanted object.
(4) Re-assemble the camera.
<Ceiling mount>
SCREW TP1
3.5x20 2EA
SCREW TP1
3.5x20 2EA
<Wall mount>
PROTECTION SHEET
LATCH BUTTON
ROTATION
U
D
R
L
LED COVER
DISK
CAMERA HOLDER
Ø100
Ø130.8
Ø109
