Huvema TL-500-AA, Инструкция по эксплуатации

Страница: 8 / 19

TL - 500 - AA
8
Material parts counter with pre-selection.
Reset button to return to the chosen number of cuts.
In order to change the selection it is necessary to keep the
reset button pressed and at the same time press the push button of
the desired digit.
- Operating mode. Sequence of operation.
With the switch of the operation modes in MANUAL POSITION, the pressing cylinders and
the saw blade may be operated by means of the push buttons at the front side of the machine. It is
recommended not to use materials with a too high feeding speed of the saw blade, because this
reduces the longevity of the saw blade and the cutting quality enormously. The machine in
MANUAL POSITION also counts the number of cuts, although it does not stop the saw blade
when reaching the zero digit.
In order to operate the feeder, the following procedures must be complied with:
1. Adjust the desired sawing height by means of the limit switch located in the inner part of the
machine, always with the operating switch turned off.
2. Adjust the feeding length with the guiding wheel of the feeder. The read-out appears on the
counter located in the spindle.
3. Adjust the pressing cylinders of the machine and those of the clamping device of the feeder
to the material, so that a space of no more than 5 mm is realised. It is important that the
microswitch of the present material (placed in the clamping device of the feeder) is
pressed
, and that the piece counter does not indicate zero. In contrast, it will
not be possible to either have the saw blade turn or to put the feeder in
operation
.
4. Place the rod on the feeder, so that it passes at a distance of approximately 10 mm from
the groove of the saw blade.
5. Assemble the operating switch.
6. Start operating the saw blade.
7. Choose the operating procedure, AUTOMATIC.
8. Start the operating cycle by pressing the start button of the feeder.