Huvema HU 40 GTF Super Vario, Руководство пользователя

Страница: 8 / 30

6
B1
Fig.6
B
4.2 Minimum Requirement for Housing the Machine
Please comply with the following terms to maximize the life and performance of the machine and its
components.
The Main voltage and frequency complying with the requirements for the machine’s motor.
Environment temperature from –10°C to +50°C.
Relative humidity not over 90%.
Altitude not over 1000m
4.3 Anchoring the Machine
-Position the machine on a firm and level concrete floor.
-Maintain a minimum distance of 800mm from the wall to
rear of the machine.
-Anchor the machine to the ground, as shown in the diagram,
using screws and expansion plugs or sunken tie rods that
connect through holes in the base.
-Ensure that it is sitting level.
4.4 Assembling Loose Parts
A. Attach Riser handle to the necessary crankshaft.
4.5 Electrical Connection of the Machine
Make sure whether the voltage of the acquired machine is
220V/1 phase or (220V, 380V, 400V,440V)/3 phases prior to
connection. If the machine cannot be operated after wires
have been connected, please check the following items:
1. Is the Emergency switch released?
2. Is the door of the electrical cabinet properly closed
and switched to ON (locked) position?
3. Is the safety guard in the proper position (closed)?
4. Is the down-feed rate set to “0”?
4.6 Coolant
Before operating a new machine, add coolant to the coolant
tank by looking at the pilot (window) indicator at the right wall
of base, fill the coolant to at least half way through the
window (A, Fig.5) (minimum 6 liters). User can choose the
one most suitable for their requirements. For your reference
SHELL LUTEM OIL ECO is highly recommended.
The ratio of oil and water is 50% respectively.
The minimum percentage of oil diluted in water is 8~10%.
Cleaning is required when iron filings clog the screen
(B,Fig.6) at the bottom right corner of the water drain entry
at the base.
Please refer to the drawing A1and B1 on the machine for
clear indication.
Riser handle
A1
Fig.
5
A