Huvema HU 355 DRYCUTTER-2, Руководство пользователя

Страница: 7 / 12

7
CHANGES AND T YPING ERRORS RESERVED CHANGES AND T YPING ERRORS RESERVED
• Install new blade (G) making certain teeth of saw blade are pointing down at the front and re- assemble outside
blade flange (F), washer (E) and arbor screw (D). Turn arbor (D) clockwise to tighten.
• Replace saw blade cover that was remove in step 2.
MAKE SURE ARBOR LOCK (C) IS DISENGAGED AND 8 MM HEX WRENCH IS REMOVED BEFORE
TURNING ON THE POWER.
4.3 a
djusTinG THe sTaTionary vise and THe cuTTinG anGle
Figure 10
The stationary vise can be positioned by loosening the adjustment bolts (G), sliding the fence (H) to the desired
position and retightening the bolts. The maximum width capacity is approximately 7-1/4" at 90° and 5" at 45°.
The vise angle can be adjusted from 0
0
to 45° right.
Loosen the adjustment bolts on the vise (G), then set the vise to the desired angle. Tighten the two bolts. The
moveable vise (F) will automatically align.
4.4 b
iG blade Guard and small blade Guard
When the saw head is pressed down, the big blade guard and small blade guard separate to cut the material.
4.5 c
leaninG THe cHip Tray
Figure 11
Loosen the screw (A), take out the chip tray (B) and clear it. Replace the tray and tighten the screw.
G
f
H
a
b