14
CHANGES AND T YPING ERRORS RESERVED
CHANGES AND T YPING ERRORS RESERVED
CHANGES AND T YPING ERRORS RESERVED
10
- Loosen C thumb knob for adjust the device
angle.
5.9 Install the vertical press on the vise jaws
for bundle cutting (optional)
- Standard press capacity is (W x H) 250~485 x
50~160 mm. Vise plates height 165 mm
- Special press capacity is (W x H) 250~485 x
200~300 mm. Vise plates height 300 mm
- Open the vise more than 250mm.
- Attach and Tighten posts bolts’ (A) on to vises.
Then attach the vertical press to the top of the
post bolts. Connect the Hydraulic connector (B).
- Attach the nuts (H) on to the posts, but do not
make the nut (H1) on moveable vise jaw too
tight. *Otherwise, the vise won’t be able to
clamp the work piece or the post bolts will be
damaged.
- Adjust the vise press (E) to sit approximately 5-
8mm above the work piece. Loose nut (C) and
rotate the bolt (D) to raise or lower the vise
press (E).
- Adjust the vise press width to fit the work piece
size. Loosen screws (F) on both sides of the
vise press then move press extender bars (G)
desired width.
- Turn OFF the hydraulic pump.
- Attach the hydraulic hose to connecter (B) and
then attach the quick link connecter (J) to the
90-degree fitting.
- Switch ON the hydraulic pump.
6 OPERATION CYCLE
6.1 Operation cycle
- Turn on the main connect switch A. on the door
of electrical box.
- Turn the key to automatic operation mode L1 to
unlock the machine. The indicator light B should
be lit.
- Start the hydraulic system, use switch C.
- Press the selector D to manual operation mode
D1, and its indicator light will be lit.
- Raise the saw bow, Use bow up switch E.
- Open the vise, use vise open switch F.
- Load the working material.
- Secure the material, use the vise close switch G.
- Base on the diameter of the material; set the
saw bow’s height Q.
- Choose the blade speed appropriate for the
material.
- Set the saw bow return height for cutting many
pieces.
- Select the operation cycle mode 6.1 D2 to press
the selector 6.1 D. The indicator light will be lit.
Laser guide device
C
A
B
H
D
C
H1
A
E
F
G
B
J
Содержание HU 331 DGH
