Huvema HU 32 SUPER VARIO, Руководство пользователя

Страница: 4 / 24

4
CHANGES AND T YPING ERRORS RESERVED CHANGES AND T YPING ERRORS RESERVED CHANGES AND T YPING ERRORS RESERVED
2. a
DDiTional safeTy rUles
Always keep in mind that:
• the machine must be switched off and disconnected from the power supply during maintenance and repairs,
• clamped workpieces may only be measured when the machine is switched off.
Never lean over the machine, mind loose clothing, ties, jewellery etc. and wear a cap.
Do not remove safety devices or guards. Never use the machine while a guard is open.
Always use safety glasses for machining rough materials.
Burrs and chips should only be removed using a sweeper or other aid, never with your bare hands!
Never leave the machine running unattended.
3. U
npacking
Before unpacking, make sure the packaging is not damaged, broken or parts of the machine are sticking out; if any
of these defects are found, contact your retailer as soon as possible.
• Carefully open the packaging (pull it from the bottom to the top).
• Take out and read the manual; check if the machine is complete.
• Check if the machine is in good condition. There should be no damage, cracks or rust.
• Clean the surface of the machine.
3.1 T
ransporTaTion insTrUcTion
• Please refer to the machines specifications for proper machine handling. Be sure to use a suitable forklift or hoist
for lifting the machine.
• Handling and transportation must be carried out by qualified personnel.
• A forklift or hoist must be operated by a qualified driver.
• During transaport, always keep the machine well balanced.
• The machine must be lifted only vertically.
•
Before handling, make sure all moving parts are secured and all detacheable accessories are removed from the
machine.
• Make sure the lifting straps are strong enough to hold the machine.
• Make sure the machine cannot bump or crash into anything. This will influence machine precision and may
damage the electronic control.
Always wear safety glasses!
Typical lifting strap position.
1-3. Setting the machine instruction :
1. The machine base with setting hole will be set on concrete floor.
The outlined procedures of setting the machine
MODEL AREA SETTED SCREW
JS-834 X=900×700 M12
JS-834V X=900×700 M12
JS-840VB X=900×700 M12
2.
The dimension of setting hole:
Consider existing and anticipated needs, size of material to be processed through each machine, and
space for auxiliary stands, work tables or other machinery when establishing a location for your
machine. See Figure 01.
JS-834/834V/840VB
Dimensions(m/m)
JS-834/834V
A=1000
B=560
JS-840VB
A=1050
B=580
2
Lifting Straps
Figure 01
Figure 1