garden and landscaping products
H
H
UTTO
UTTO
N
N
Assembly Instructions
WA
– Westbury Arbour Seat
Your Arbour is in seven sub-assembled sections, two loose
armrests, a bag of fixings and instructions. Some basic tools
will be required to assemble the Arbour Seat.
1. On clean, level ground, assemble your Arbour Seat
horizontally on the ground.
2. Slide the seat into position between the two Side Panels
with the trellis flush to the outside. Line up the 11mm
predrilled holes in the front Side Sections and Seat. The
front of each trellis is defined by a small, pre-drilled hole in
the trellis frame, 735mm from the base of the post. Push a
cap in to the post and pass a 95mm long bolt through from
the other side. Repeat for the other connection and tighten
up with two Allen Keys provided.
3. Now, with help if necessary, lift this Assembly into a vertical
position with the rounded ends of the Seat facing you. This
will now be the front of your Seat.
When assembling, loosely
bolt together until fully
assembled then tighten all
the bolts.
List of parts in fixings pack
Sub Assemblies
2 x Roof Sections
2 x Side Trellis Sections and
Uprights
1 x Back Trellis Section
1 x Seat
1 x Seat Back
2 x Armrests
Fixings
6 x M8 x 95 Con. Bolts
6 x M8 Con Caps
8 x 90mm Screws
10 x 60mm Screws
12 x Screw Cups
2 x Allen Keys 5mm
4 x Rubber Bungs
Tools required (not provided)
1 x No.2 Pozidrive Screwdriver or
a battery or electric drill with
No.2 Pozidrive bit.
This makes life
easier, but is not essential
continued overleaf
