26
MAINTENANCE INSTRUCTIONS
Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces
#OSO-29 #OSO-34 R.1 November 2020
7.0 MAINTENANCE INSTRUCTIONS
ALWAYS turn off the appliance and remove from power before cleaning,
performing maintenance, or moving this appliance. Failure to do so
could result in an electric shock, fire, or personal injury.
NEVER immerse in water or spray with water. Doing so could result in
an electric shock, fire, or personal injury.
7.1 Cleaning
This appliance will require maintenance which should be planned on
an annual basis.
7.1.1 Metal
•
Clean using a soft cloth that is slightly dampened with soapy
water.
•
DO NOT use with brass polish or household cleaners, as these
products will damage the metal trim.
7.1.2 Glass
•
Use a quality glass cleaner sprayed onto a cloth or a towel. Dry
thoroughly with a paper towel or lint-free cloth.
•
NEVER use abrasive cleaners, liquid sprays, or any cleaner that
could scratch the surface.
7.1.3 Vents
•
Use a vacuum or duster to remove dust and dirt from the heater
and dust areas.
7.1.4 Plastic
•
Wipe gently with a slightly damp cloth and a mild solution of
dish soap and warm water.
•
NEVER use abrasive cleaners, liquid sprays, or any cleaner that
could scratch the surface.
7.2 Maintenance
WARNING - Risk of electric shock! DO NOT OPEN any panels. There are
no user-serviceable parts inside.
WARNING: No servicing of the internal or electrical parts should be
performed by the consumer. Do not service the appliance yourself.
7.2.1 Electrical and Moving Parts
•
The fan motors are factory lubricated and do not require
lubrication.
•
Electrical components are integrated in the appliance and are
not serviceable by the consumer.
7.2.2 Storage
•
Store heater and power cord in a clean, dry place when not in
use.
7.3 Remote Control Battery Information
WARNING: Keep batteries out of reach of children.
NEVER dispose of batteries in a fire. Failure to observe this precaution
may result in an explosion. Properly dispose of your batteries at your
local hazardous material processing center. Check with your local
authority for recycling instructions.
•
The remote control uses one CR2025 battery (included).
•
To replace the battery,
1. Remove the battery holder. The battery holder is equipped
with a child lock. To remove the battery holder, turn remote
onto the rear side. Press the left side lever towards the center
while pulling the battery holder out of the slot.
2. Replace existing battery, type CR2025, with a new battery.
3. Slide the battery holder into position. The battery holder is
connected to the remote when you hear a ‘click.’
Figure 7.1, Remote Control Battery Replacement
Remote (rear side)
Battery Holder
Battery (CR2025)
