CLEANING UNDER MERCHANDISERS
Remove splashguards not sealed to floor. Use a
vacuum with a long wand attachment to remove
accumulated dust and debris from under the mer-
chandiser.
REMOVING SCRATCHES FROM BUMPER
Most scratches and dings can be removed using
the following procedure.
1. Use steel wool to smooth out the surface area
of the bumper or top rail.
2. Clean area.
3. Apply vinyl or car wax and polish surface for
a smooth glossy finish.
CLEANING HONEYCOMB ASSEMBLIES
Honeycombs should be cleaned every six months.
Dirty honeycombs will cause merchandisers to
perform poorly. The honeycombs may be cleaned
with a vacuum cleaner. Soap and water may be
used
if all water is removed from the honeycomb
cells
before reinstalling. Be careful not to damage
the honeycombs.
REMOVING INTERIOR BACK PANELS
The interior back panels may be removed for
cleaning and to gain access to the evaporator coils.
Remove the rear interior back panels as follows:
1.
D
ISCONNECT THE ELECTRICAL POWER TO THE
MERCHANDISER
.
2. Remove shelving.
3. Lift the panel up, then pull forward and out.
4. Replace panels.
5. After cleaning or servicing the merchandiser,
reconnect the electrical power.
