INSTALLING SPLASHGUARDS
The splashguard is shipped inside each merchan-
diser.
A
FTER
merchandisers have been leveled
and joined, and all drip piping, electrical and
refrigeration work has been completed, install the
splashguard.
To Install Splashguards:
1. Check to be sure
that all splashguard
brackets are level
with the floor.
2. Position top of
splashguard over
the top edge of the
bracket as shown
below.
3. Push the lower
edge of the splash-
guard toward the
bottom of the
bracket until it
snaps into place.
SEALING SPLASHGUARD TO FLOOR
I
F REQUIRED
by local sanitation codes, or if
desired by the customer, plastic splashguards may
be sealed to the floor using silicone type sealer.
The amount needed will depend on how much the
floor is out of level.
1. Remove all dirt, wax and grease from the area
of the splashguard where adhesion will be
necessary. This is to ensure a good and secure
installation.
2. Apply a good silicone type sealer along the
bottom of the splashguard. Sealant must be
removed and replaced when servicing.
O
PTIONAL S
tainless steel splashguards may be
sealed to the floor using a vinyl cove base trim.
The size of trim needed will depend on how much
the floor is out of level.
To install the trim to the splashguard:
1. Remove all dirt, wax and grease from the area
of the splashguard where adhesion will be
necessary. This is to ensure a good and secure
installation.
2. Apply a good contact cement to the cove trim
and allow proper drying time according to the
directions supplied with the cement.
3. Install the trim to the splashguard so that it is
lying flush with the floor. D
O NOT SEAL THE
TRIM TO THE FLOOR
.
4.
If required by local health codes
the Cove
Trim may be sealed to the floor, using a sili-
cone type sealer. Sealant must be removed and
replaced when servicing.
Splashguard
Silicone-type
Sealer
Splashguard
Cove Trim
Cement
Splashguard
Bracket
Base of Case
Splashguard
1.
2.
3.
