Husqvarna Wacker Neuson MCT36-5, Руководство оператора

Страница: 40 / 52

wc_tx004558en.fm
40
Maintenance MCT36-5 CN
5.11 Trowel Lubrication
Apply an appropriate grease to the trowel arm grease fittings
(a)
. Oil the pitch
control cable and other parts of the trowel on an as-needed basis.
Oil in the gearbox should not require replacement unless it was drained to service
the gearbox. Check the quantity through the sight glass
(b)
located on the side of
the gearbox. The oil level should be centered on the red dot in the middle of the
sight glass as shown. See
Technical Data
for the oil quantity and type.
5.12 Storing the Machine
The following steps should be taken to prepare the machine for extended storage:
1. Close the fuel shut-off valve.
2. Siphon excess gasoline from the tank.
3. Run the engine until it stops from lack of fuel. This will use up all the fuel in the
carburetor and prevent formation of deposits due to evaporation of fuel.
4. Remove the spark plug and pour 60 mL (2 oz.) of SAE-30 or SAE-40 motor oil
into the cylinder. Slowly crank the engine 2 or 3 times to distribute the oil
throughout the cylinder. This will help prevent rust during storage. Replace the
spark plug.
5. Store the unit in an upright position in a cool, dry, well ventilated area.
a
b
a
b
a
wc_gr014645