Husqvarna W520i, Руководство оператора

Страница: 26 / 80

When you operate the product, the cut grass discharges
below the rear cover.
Maintenance
Introduction
WARNING:
Before you do
maintenance, you must read and
understand the safety chapter.
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not a
service agent, speak to them for information about the
nearest service agent.
Maintenance schedule
The maintenance intervals are calculated from daily use
of the product. The intervals change if the product is not
used daily.
For maintenance identified with *, refer to
Safety
instructions for operation on page 18
.
Each use Monthly
Each
season
Do a general inspection X
Clean the transmission covers. Make sure that the motor does not have grass on
it
X
Do a check of the start inhibitor * X
Make sure that the safety devices on the product are not defective * X
Check the grass catcher for wear or deterioration X
Examine the cutting equipment X
Examine the cutting cover * X
Do a check of the motor brake handle * X
Make sure that the ON/OFF button operates correctly and is not defective X
Examine the battery for damage X
Do a check of the battery charge X
Make sure that the release buttons on the battery operates correctly and that the
battery locks into the product
X
Clean the air intakes. Make sure that the air intakes does not have grass or dirt
on them
X
Examine the battery charger for damage and make sure that it operates correctly X
Clean below the clutch cover X
Examine the connections between the battery and the product. Also examine the
connection between the battery and the battery charger
X
To do a general inspection
• Make sure that the nuts and screws on the product
are tightened.
• Make sure that the cables on the product are not in a
position where they can get damaged.
To replace the blade
1. Lock the blade with a block of wood. (Fig. 58)
2. Remove the blade bolt, the spring washer and the
blade. (Fig. 59)
3. Examine the blade support and blade bolt for
damages.
a) If you replace the blade or the blade support,
also replace the blade bolt, the spring washer
and the friction washer.
26 1484 - 005 - 23.09.2020