Husqvarna TC 85 2020, Руководство пользователя

Страница: 111 / 136

SERVICE WORK ON THE ENGINE 16
109
Guideline
Oil drain plug with
magnet M12 20 Nm (14.8 lbf ft)
401955-11
–
Remove filler plug
2
with the O-ring, and fill up with gear oil.
Gear oil 0.50 l
(0.53 qt.) Engine oil (15W/50)
(
p. 125)
–
Mount and tighten filler plug
2
with the O-ring.
Danger
Danger of poisoning
Exhaust gases are toxic and
inhaling them may result in unconsciousness and
death.
–
Always make sure there is sufficient ventilation
when running the engine.
–
Use effective exhaust extraction when starting or
running the engine in an enclosed space.
–
Start the engine and check that it is oil-tight.
Finishing work
–
Check the gear oil level. ( p. 108)
16.3 Adding the gear oil
Info
Too little gear oil or poor-quality gear oil results in premature wear to the transmission.
Preparatory work
–
Stand the motorcycle upright on a horizontal surface.
V01305-10
Main work
–
Remove screw
1
with the seal ring.
401955-11
–
Remove filler plug
2
with the O-ring.
–
Add gear oil up to the bottom edge of the hole of the gear oil
level plug.
Engine oil (15W/50) ( p. 125)
–
Mount and tighten screw
1
with the seal ring.
Guideline
Screw, gear oil level
monitoring M6 8 Nm (5.9 lbf ft)
–
Mount and tighten filler plug
2
with the O-ring.