Husqvarna TC 50 2023, Руководство пользователя

Страница: 117 / 196

SERVICE WORK ON THE ENGINE 16
115
K01173-10
(TC 50)
–
Position an appropriate container under the engine.
–
Remove oil drain plug
1
with the magnet.
–
Let the gear oil drain fully.
–
Thoroughly clean the oil drain plug with magnet.
–
Clean the sealing surface on the engine.
–
Mount and tighten the oil drain plug with the magnet and
new seal ring.
Guideline
Oil drain plug with
magnet
M12x1.5 20 Nm (14.8 lbf ft)
K01166-10
–
Remove filler plug
2
with the O-ring, and fill up with gear oil.
Gear oil 0.20 l
(0.21 qt.)
Gear oil
(ATF Dexron 3)
( p. 138)
Info
Too little gear oil or poor-quality gear oil results in pre-
mature wear to the transmission.
–
Mount and tighten filler plug
2
together with the O-ring.
Danger
Danger of poisoning
Exhaust gases are toxic and
inhaling them may result in unconsciousness and
death.
–
Always make sure there is sufficient ventilation
when running the engine.
–
Use effective exhaust extraction when starting or
running the engine in an enclosed space.
–
Start the engine and check it for leaks.
Finishing work
–
Check the gear oil level. ( p. 113)
16.5 Adding the gear oil
Info
Too little gear oil or poor-quality gear oil results in premature wear to the transmission.
Preparatory work
–
Stand the motorcycle upright on a horizontal surface.