Husqvarna TC 50 2023, Руководство пользователя

Страница: 104 / 196

14 COOLING SYSTEM
102
Condition
The engine is cold.
K01159-10
–
Position the motorcycle upright.
–
Place an appropriate container under the water pump cover.
–
Remove screw
1
. Take off the radiator cap.
–
Completely drain the coolant.
–
Mount and tighten screw
1
with a new seal ring.
Guideline
Drain plug, water
pump cover
M6 6 Nm (4.4 lbf ft)
14.5 Refilling with coolant
Warning
Danger of poisoning
Coolant is harmful to health.
–
Keep coolant out of the reach of children.
–
Do not allow coolant to come into contact with the skin, the eyes and clothing.
–
Consult a doctor immediately if coolant is swallowed.
–
Rinse the affected area immediately with plenty of water in the event of contact with the skin.
–
Rinse eyes thoroughly with water and consult a doctor immediately if coolant gets into the eyes.
–
Change clothing if coolant spills onto your clothing.
K01162-10
Main work
–
Make sure that screw
1
is tightened.
–
Position the motorcycle upright.
–
Add coolant to level
A
.
Guideline
Distance
A
above the radi-
ator fins
10 mm (0.39 in)
Coolant 0.7 l (0.7 qt.) Coolant ( p. 137)
400677-11
–
Move the vehicle into the position shown and prevent it from
rolling away. Height difference
B
must be reached.
Guideline
Height difference
B
50 cm (19.7 in)
Info
For all of the air to be able to escape from the cooling
system, the vehicle must be raised at the front. If the
cooling system is poorly de-aerated, its cooling power
will be reduced and the engine may overheat.
–
Return the vehicle to the horizontal position.
–
Add coolant to level
A
.
–
Mount the radiator cap.
Finishing work
–
Go for a short test ride.
–
Check the cooling system for leaks.