Husqvarna TC 242TX, Руководство оператора

Страница: 20 / 280

1. Push the forward drive pedal (B) down. Keep the
forward drive pedal in a position that gives the
correct speed for the terrain.
A
B
2. Pull the cruise control lever (A) up and hold it while
you release the forward drive pedal.
3. Release the cruise control lever to engage the cruise
control.
4. Push the brake pedal or tap on the forward drive
pedal to disengage the cruise control.
To use the headlight
• Push the power switch to position (A) to make the
headlight come on.
A
B
• Push the power switch to position (B) to make the
headlight go off.
To engage and disengage the cutting
deck
The product has an operator presence control (OPC).
When you go away from the seat with the engine on and
the cutting deck engaged, the engine stops.
Stay fully and in the center of the seat to make sure
that the engine operates correctly and does not stop on
rough terrain or hills.
1. Set the correct cutting height. Refer to
To set the
cutting height on page 18
.
2. Move the attachment clutch control.
a) Pull the attachment clutch control upwards to
engage the cutting deck.
b) Push the attachment clutch control down to
disengage the cutting deck.
To operate the EZ mulch lever
A
1. Move the mulch lever (A) to the low position to
engage the mulch function.
2. Move the mulch lever (A) to the high position to
disengage the mulch function.
To use the reverse operation system
(ROS)
Note:
If you try to go rearward with the product
when the cutting deck is engaged, the engine stops
immediately. Engage the ROS to go rearward with the
product when the cutting deck is engaged.
WARNING:
Before and while you
operate the product rearward, look down
and behind the product for the safety of
others.
20 1923 - 005 - 13.10.2022