Husqvarna T535i XP, Руководство оператора

Страница: 11 / 96

Assembly
To assemble the guide bar and saw
chain
WARNING: Always remove the battery
before you assemble or do maintenance on
the product.
1. Disengage the chain brake.
2. Remove the bar nut, the drive sprocket cover and
the transportation ring (A).
A
3. Put the guide bar on top of the bar bolt. Steer the
guide bar to its most rear position. Lift the saw chain
above the drive sprocket and engage it in the groove
on the guide bar. Start on the top edge of the guide
bar.
4. Make sure that the edges of the cutting links are
turned forward on the top edge of the guide bar.
5. Assemble the drive sprocket cover and steer the
chain adjuster pin to the hole in the guide bar.
6. Make sure that the drive links of the saw chain fit
correctly on the drive sprocket.
7. Make sure that the saw chain is correctly engaged in
the groove in the guide bar.
8. Tighten the bar nut finger-tight.
9. Tighten the saw chain. See
To adjust the tension of
the saw chain on page 22 for instructions.
959 - 007 - 11