Husqvarna PP 70, Руководство оператора, Страница: 7 / 72

To do a check of the machine stop button
1. Turn the machine stop button on the product to
make sure it is disengaged (A).
A
B
2. Start the connected power tool.
3. Push the machine stop button and make sure that
the connected power tool stops.
RCD
The product has an integrated RCD. The RCD is a
protection for the operator if an electrical fault occur.
To do a check of the RCD 3 phase
1. Start the product, refer to
To start the product on
page 9 .
2. Look into the inspection holes and push the RCD
test button.
3. Make sure that the RCD moves and that it
disconnects the product from the power supply.
4. Turn the RCD reset knob to reset the RCD.
To do a check of the RCD, 1 phase
1. Connect the product to the outlet. Use the correct
adapter. Refer to
Adapters on page 16
.
2. Push the RESET button (green) and the red LED
lights up.
3. Start the product.
4. Push the TEST button (blue).
5. The RCD must trip and the product must stop
immediately. If not, speak to your Husqvarna dealer.
6. Push the RESET button (green).
Safety instructions for maintenance
WARNING: Read the warning instructions
that follow before you do maintenance on
the product.
• Not approved changes and/or accessories can
cause serious injury or death to the operator or
others.
• Only Husqvarna service centers must open the
enclosure and do service to the product.
• Do the daily maintenance to make sure that the
product operates correctly. Refer to
Maintenance on
page 10 .
• Do the inspection and/or maintenance with the motor
stopped and the power plug disconnected.
• Clean the product with water. Do not use high
pressure washer. Do not point the water at electrical
components or bearings.
• Only let an approved service person do service on
the product. Use only Husqvarna or equivalent
replacement parts.
1244 - 002 - 18.05.2020 7