To operate the product
1. Set the throttle control in the operation position.
2. Hold the handle and move the product in the
necessary direction.
CAUTION: Do not push the product
down. Too much pressure can cause
unsatisfactory result.
3. Make sure that the rammer shoe is parallel to the
ground during the operation.
To stop the product
• Set the throttle control in the stop position.
Maintenance
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance on the
product.
Maintenance schedule
* = General maintenance done by the operator. The
instructions are not given in this operator's manual.
X = The instructions are given in this operator's manual.
O = Refer to the engine manual for instructions.
General product maintenance
Before use,
each 10 h
After the
first 20 h
Weekly,
each 100 h
Yearly, each
500 h
Make sure that there are no fuel or oil leaks.
*
Clean the product.
X
Make sure that nuts and screws are tightened.
*
Examine the throttle control and choke control for dam-
age.
*
Make sure that the throttle control and the choke control
can move smoothly.
*
Do a check of the oil level in the rammer leg.
X
10
957 - 002 - 14.10.2019
